Evga nForce 630i Manual do Utilizador descarregar pdf

Before You Begin…

Parts NOT in the Kit

This kit contains all the hardware necessary to install and connect your new EVGA

e-7050/610i GPU motherboard with integrated GeForce graphics processing. However, it

does not contain the following items that must be purchased separately to make the

motherboard fully functional.

 Intel microprocessor:

 Cooling fan and heat sink for the microprocessor

 System memory support

 Hard Disk Drive(s)

 Operating System

 Power Supply

 Graphics Card

EVGA assumes you have purchased all necessary parts needed to allow for proper system

functionality.

Motherboard Specifications

 Size

mATX form factor.

 Microprocessor support

Intel Core 2 Extreme, Intel Core 2 Quad, Intel Core 2 Duo, Pentium EE, Pentium, and

Celeron. (The e-7050/610i supports up to 1066MHz FSB CPU’s)

 Operating systems

Supports Windows XP and Windows Vista.

 Contains an NVIDIA nForce MCP and integrated GeForce graphics

 System Memory

• Single-channel DDR2 667/533

• Supports up to 4 GB DDR2 memory (2GB x 2)

 USB 2.0 Ports

• Supports hot plug

• Up to eight (4 onboard) USB 2.0 ports

• Supports USB 2.0 protocol up to 480Mbps transmission rate

1 2 3 4 5 6 ... 10 11

Resumo do Conteúdo

Página 1 - Motherboard Specifications

Before You Begin… Parts NOT in the Kit This kit contains all the hardware necessary to install and connect your new EVGA e-7050/610i GPU

Página 2

Audio The audio connector supports the HD audio standard. Most cases come with a 10 pin standard block which will align and plug directly in to

Página 3 - EVGA nForce Motherboard

Expansion Slots The EVGA nForce motherboard contains four expansion slots, two PCI Express slots and two PCI slots. PCI Slots The two PCI slots sup

Página 4

 Onboard Serial ATA II • 3Gb/s data transfer rate • Four Serial ATA II connectors • Support for RAID 0, RAID 1 • Supports hot plug and NCQ (Nat

Página 5

Hardware Installation This section will guide you through the installation of the motherboard. The topics covered in this section are: • Preparing

Página 6 - Preparing the Motherboard

1. 2. 3. 4. 5. 6. 7. 8. 9. 10 11 10 CPU Socket NVIDIA MCP with 4-Pin CPU Fan CoDDR2 DIMM MemFDD Connector 24-Pin ATX Pow

Página 7 - Installing the Motherboard

1. PS/2. LAN 3. PS/4. e-75. USB6. AudGrePinOraBlaGre /2 Keyboard PoN Port with LED /2 Mouse Port 7050 IntegratedB 2.0 ports (Fodio Po

Página 8

Preparing the Motherboard Installing the CPU Be very careful when handling the CPU. Hold the processor only by the edges and do not touch the bottom o

Página 9

Installing the Motherboard The sequence of installing the motherboard into the chassis depends on the chassis you are using and if you are replacing a

Página 10 - Fan Connections

Pow24-p8-pin FD Cower ConThis motheprovide enin ATX PowPWR1 is thDIMM sloconnector make sure n ATX 12V PPWR2, thethe pins to only fit in o DD Connec

Página 11 - Expansion Slots

CoTco CoPlL USB onnecting SThe Serial AATA II devthe thin Securrent Sertransfer ratThere are four onnectors suponnecting Ilease refer to ayout f